Department of Dry Basements
Sump Pump Installation in Oakville
A sump pit with no pump, or a pump that has run its last cycle. Installation is the first line of defence below grade.
- Clear diagnosis before any cutting or replacing
- Price explained before the work starts
- Tested with water running before we leave
- Booked by phone, no forms
or ring (365) 399-5986Real people answer. Bookings by phone only.
- Licensed & insured (details on request)
- Oakville & Halton
- Phone bookings only
The parts of a sump system
Foundation weeping tiles collect groundwater and lead it to a pit in the basement floor. A pump in that pit lifts the water out through a discharge pipe to the yard. A check valve stops water falling back into the pit, and a float switch tells the pump when to run.
Installation can mean replacing a worn pump in an existing pit, or, in a home that never had one, cutting the floor, setting a liner and connecting to the weeping tile. The second is a bigger job and may need permits.
Job sheet: Sump Pump Installation in Oakville
- Where we get in
- Sump pit in the basement floor and the discharge route outside
- On the van
- Submersible pump, check valve, ABS discharge pipe, pit lid, float switch
- Before we pack up
- Pit filled with a hose until the pump kicks on and clears it
- How to book
- Phone only: (365) 399-5986
Why Oakville homes rely on them
Many Oakville neighbourhoods sit on clay soils that hold water. Newer subdivisions were often built with foundation drains discharging to a sump rather than the sanitary sewer. Spring melt and heavy summer storms keep pumps busy.
Signs you need this now
- No pump in an existing pit
- Old pedestal pump that is rusting
- Water on the slab after storms
- Discharge line frozen or crushed outside
- Pump older than about ten years
What to check on your current pump
- Empty a full pail into the pit. Does the pump start and stop on its own?
- Listen for grinding or rattling.
- Look at where the discharge empties outdoors; it should run away from the house.
- Note the pump's age if a label is visible.
Oakville bylaws generally forbid sending sump water into the sanitary sewer. Ask about the current municipal rules.
The visit in five steps
- 1Clean out the pit and inspect the liner
- 2Set the pump level with free float travel
- 3Plumb the discharge with a check valve
- 4Route discharge well away from the foundation
- 5Fill the pit and watch it cycle
Installation day
The pit is cleaned, the new pump set level on a firm base, discharge piping and check valve installed, and the unit tested several times with water. We show you how to test it yourself each season.
Add protection
Power cuts arrive with storms. A battery backup pump keeps going when the hydro does not. If an older pump is merely acting up, try sump pump repair first.
Straight answers to common calls
Roughly how many years does a sump pump give?
It varies with how hard it works. Many owners replace pumps proactively rather than wait for failure.
Does every house need a sump pump?
No. It depends on how the foundation drains were built. A look at your basement floor tells us.
Keep reading
- Sump Pump Repair in Oakville
A sump pump sits quiet for months, then has one job to do during the heaviest storm of the season.
- Battery Backup Sump Pump in Oakville
The storm knocks out the power at exactly the moment the sump pit fills.
- Signs Your Sump Pump Is Failing
The sump pump sits in a hole in the basement floor and works quietly for years.
- Preventing Basement Flooding in Oakville
Most basement floods start outside the house or in the sewer.
Ready when you are
One call books the visit. Tell us what you are seeing and we will tell you straight what it likely is.