Skip to content
(365) 399-5986

Department of New Lines

Whole-Home Repiping in Oakville

Patch after patch, leak after leak. At some point the smart move is to replace the water lines through the whole house.

  • Clear diagnosis before any cutting or replacing
  • Price explained before the work starts
  • Tested with water running before we leave
  • Booked by phone, no forms
Call now

or ring (365) 399-5986Real people answer. Bookings by phone only.

  • Licensed & insured (details on request)
  • Oakville & Halton
  • Phone bookings only
A workbench with clamps and hand tools
A workbench with clamps and hand tools.

What repiping means

Whole-home repiping replaces the supply piping that carries fresh water to every fixture. The old lines, often galvanized steel or polybutylene, are abandoned or removed and new copper or PEX is run from the primary shut-off to each fixture. Drains are a separate matter and are usually left alone unless they are also failing.

Job sheet: Whole-Home Repiping in Oakville

Where we get in
Basement ceilings, closets and small access cuts in walls
On the van
PEX-A or copper, expansion tool, manifold, hangers, fire-stop sealant
Before we pack up
Whole system pressure test before walls close
How to book
Phone only: (365) 399-5986

Homes that often need it

Oakville houses from the post-war decades may still have galvanized steel, which rusts inside and chokes flow. Homes from the late 1970s through the mid-1990s may have grey polybutylene, known as Poly-B, which some insurers flag. Either one is a common reason to repipe. See galvanized pipes and identifying Poly-B.

Signs you might be there

  • Low pressure at several fixtures at one time.
  • Brown or rusty water after the faucets sit.
  • Repeated pinhole leaks.
  • An insurer asking about pipe material.

The visit in five steps

  1. 1Map every fixture and existing run
  2. 2Plan new routes with fewest wall cuts
  3. 3Run new pipe while old stays live
  4. 4Switch fixtures over one at a time
  5. 5Test, then patch openings

Planning the work

PEX is flexible and can often be fished through walls with small openings, which keeps damage down. Copper is rigid and long-lived but needs more access. We map the route, list the openings needed, and agree on a schedule so water is off for as short a time as possible each day.

Ask whether your water service line from the street is also old. Replacing it at the same time can be sensible. See service line replacement.

How the project unfolds

New lines are run alongside the old while the house stays in service, then each fixture is switched over. The system is pressure-tested, flushed and checked at every outlet. Openings are left clean and ready for patching.

Also consider

If only Poly-B is the concern, our Poly-B replacement page covers that focused job.

Straight answers to common calls

How long does repiping take?

It depends on size and access. A typical detached home takes several days.

Do I have to relocate out?

Usually not. Water is restored at the end of most working days.

Keep reading

Ready when you are

One call books the visit. Tell us what you are seeing and we will tell you straight what it likely is.

Call (365) 399-5986
Call now · (365) 399-5986