Skip to content
(365) 399-5986

Commercial plumbing

Jetting Long Commercial Drain Lines

Cable machines open a hole through a blockage. Jetting scours the full pipe wall, which matters on long commercial lines where grease and scale build up fast.

  • Clear diagnosis before any cutting or replacing
  • Price explained before the work starts
  • Tested with water running before we leave
  • Booked by phone, no forms
Call now

or ring (365) 399-5986Real people answer. Bookings by phone only.

  • Licensed & insured (details on request)
  • Oakville & Halton
  • Phone bookings only
Parallel pipe runs bending along a concrete service wall
Parallel pipe runs bending along a concrete service wall.

When jetting beats snaking

  • Grease-coated kitchen lines that close up again within weeks.
  • Scale inside older cast iron mains under plaza units.
  • Sand and grit in parking-level and loading-dock drains.
  • Long horizontal runs where a cable cannot reach the end.

Job sheet: Jetting Long Commercial Drain Lines

Where we get in
Main cleanout, roof stacks, floor sink cleanouts and parking-level drains
On the van
Trailer or cart jetter, grease and root nozzles, push camera, sonde locator
Before we pack up
Camera run after jetting and every fixture on the line flowed
How to book
Phone only: (365) 399-5986

The equipment

  • A jetter with hoses sized for 2-inch to 6-inch lines.
  • Nozzles for grease cutting, root clearing and debris flushing.
  • A push camera to check the line before and after.
  • Locator to mark the depth and location of problem spots.

Signs you need this now

  • Repeat snaking on the same line
  • Several floor drains slow together
  • Sewer smell near drains in the unit
  • Grit or sand backing up in a loading dock
  • Water rising in a lower unit when an upper one drains

How a jetting job runs

  1. We find the best cleanout to work from.
  2. A camera pass shows what is in the line.
  3. The jetter scours the line in sections, working downstream.
  4. The camera goes back in to prove the wall is scoured clean.
  5. You get notes on any cracks, sags or offsets we saw.

The visit in five steps

  1. 1Pick the cleanout to work from
  2. 2Camera the line to see the blockage
  3. 3Jet the line in sections downstream
  4. 4Camera again to confirm a clean wall
  5. 5Note any damage for follow-up

Is your line a candidate?

  • The same drain has been snaked more than twice this year.
  • Several fixtures back up at once.
  • You can smell sewer gas near floor drains.
  • Water appears at a floor drain when upstairs units use water.

Straight answers to common calls

Can jetting damage old pipe?

Pressure is set for the pipe material and condition. A camera check first tells us whether jetting is safe.

How long will jetting take?

Most branch lines take a few hours. Long mains or heavy grease can take longer.

Keep reading

Ready when you are

One call books the visit. Tell us what you are seeing and we will tell you straight what it likely is.

Call (365) 399-5986
Call now · (365) 399-5986